Friday, September 28, 2012

Where Can I Buy PYLE PLX462 4-Inch x 6-Inch 160 Watt Two-Way Speakers

PYLE PLX462 4-Inch x 6-Inch 160 Watt Two-Way Speakers

PYLE PLX462 4-Inch x 6-Inch 160 Watt Two-Way Speakers

Code : B0002BEWX8
Category :
Rating :
HOT PRODUCT TODAY
* Special discount only for limited time










Product Details

  • Brand: Pyle
  • Model: PLX462
  • Dimensions: 11.89" h x
    7.80" w x
    2.68" l,
    2.45 pounds

Features

  • 4'' x 6" Polypropylene Woofer Cone - 4 Ohms Impedance
  • 1'' Hi-Temp Ferro Fluid Enhanced Voice Coil - Rubber Boot Magnet Cover
  • 1'' Mylar Dome Tweeter - Includes Grills, Wires and Mounting Hardware
  • 80 Watts RMS/160 Watts Max Power - Mounting Depth: 1.9''
  • Frequency Response: 66 - 20k hz





PYLE PLX462 4-Inch x 6-Inch 160 Watt Two-Way Speakers









Product Description

These 160-watt, two-way Pyle speakers provide great sound for your car. The 4” x 6” polypropylene woofer cone has been specially designed for mobile applications. The 1” hi-temp ferrofluid enhanced voice coil and 1” Mylar dome tweeter provide rich, buttery mids and sweet highs. The full-range frequency response (66 Hz to 20 kHz) will have your sound ringing clear within the comfort of your vehicle. Includes grills, wires, and mounting hardware.





   



Customer Reviews

Most helpful customer reviews

1 of 1 people found the following review helpful.
3Pyle PLX462
By SS
Good speakers for the money. Much better then the factory speakers in my 1989 Chevy.

0 of 0 people found the following review helpful.
3Okay replacements, but not much of an upgrade
By Daxx
I bought a pair of these Pyle PLX462 speakers to replace the defective door speakers in my 2000 Grand Am. Installation was fairly easy; the speakers are a direct fit into the factory brackets, but the wiring needed some modification since the Grand Am doesn't use standard connectors. I ended up soldering some of the Pyle cable (which is merely adequate) to the end of the factory harness. Sound is... okay. These speakers have very little bass response compared to the factory speakers, and they bottom out and make "cracking" sounds with anything but the quietest bass lines or drum beats. Midrange aren't too bad, but the highs are fairly harsh. I ended up splicing a pair of 400uF capacitors into the positive wire to filter out bass below about 120Hz to stop the speakers distorting. Quality control, however, isn't that hot. One is definitely quieter than the other, and when swapping them left-to-right, the difference follows the speakers. But for under $25 they'll do until I can afford something of higher quality.

See all 2 customer reviews...



PYLE PLX462 4-Inch x 6-Inch 160 Watt Two-Way Speakers. Reviewed by Jake B. Rating: 4.0

This Page is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com
CERTAIN CONTENT THAT APPEARS ON THIS SITE COMES FROM AMAZON SERVICES LLC. THIS CONTENT IS PROVIDED "AS IS" AND IS SUBJECT TO CHANGE OR REMOVAL AT ANY TIME.

Share

Twitter Delicious Facebook Digg Stumbleupon Favorites More